Feb 27, 2018

Joining Waist Elastic without Bulk

This is a very simply tip to eliminate unnecessary bulk when sewing pull on pants with elastic in the waistband. Just follow these easy steps.

1. Cut a piece of muslin or stable cotton/poly blend fabric the width of your elastic by 3 inches. ie: If using 2" (5cm) wide elastic, cut stabilizing fabric 2" X 3". (5 x 8 cm).

2. Measure and cut your elastic to go around your waist. But make sure that is is cut exactly the measurement you need and test it to ensure that it will pull up comfortably over your hips yet not be too loose at the waist.

3. Make sure the elastic is cut with evenly squared edges.

4. Butt the edges of the elastic together. With the stabilizing fabric underneath, pin the elastic to the fabric, keeping ends of elastic as close together as possible.
5. Zig zag or straight stitch fabric to elastic keeping the edges of the elastic butted together in the middle of the fabric rectangle. Sew in a square shape and then reinforce by sewing an "X" in the middle of the square.


6. Trim off excess muslin about 1/4" from stitching.
The results are sturdy, lay flat and reduce bulk.

Here is also a very short instructional video showing you this simple process.

Blogger isn't letting me give you the video directly on this page, so here's a link to the video - takes less than 5 minutes to watch. Enjoy!

http://www.youtube.com/watch?v=RPRpjkFJ8PQ

I'm sure some of you already use this technique, but for some of you, this may be new. It's great - give it a try!

Happy Sewing!
Glenda the Good Stitch
 

3 comments:

  1. Thanks for the sewing tip. It came just as I'm preparing to repair some pants. :-)

    ReplyDelete
    Replies
    1. Happy to hear this blog post was beneficial for your sewing project.

      Delete